The NUMS MBBS and BDS merit aggregate is the NUMS test 50 percent plus FSc 40 percent plus Matric 10 percent. Convert each score to a percentage, multiply by its weight and add them. This tool uses the Session 2025-26 official weightage; always re-check the official NUMS notification for your own admission year, as the split can change each cycle.
Aggregate / NUMS test marks needed
Calculations run in your browser. Inputs are not sent to our servers; anything you Save stays in this browser only.
Saved results (0)
Which Year This Formula Covers
Read this first. This calculator uses the NUMS Session 2025-26 official weightage: NUMS test 50 percent, FSc or HSSC Pre-Medical 40 percent and Matric or SSC 10 percent. That split comes from the NUMS Centralized Admissions MBBS and BDS Session 2025-26 Combined Advertisement, read on 4 October 2026.
When this page was written, NUMS had not yet published the 2026-27 admission criteria on its official site. NUMS can revise the 50, 40 and 10 split each cycle. Before you rely on any number, open the official NUMS notification on nums.edu.pk or numspak.edu.pk for your admission year and confirm the weights still read 50, 40 and 10. If your year differs, type the correct weights into the three weight fields; they must add up to 100.
Note that NUMS runs its own entrance test, the NUMS MDCAT, which is separate from the national UHS or PMDC MDCAT. MCAT-USA and UCAT-UK are accepted only for eligible foreign or overseas applicants. For the national public-sector formula, use the MDCAT aggregate calculator instead.
How to Use the NUMS Aggregate Calculator
- Choose what to find. Keep the default to work out your aggregate, or switch to reverse mode to find the NUMS test marks you need for a target.
- Enter your NUMS test, FSc and Matric marks. Type the marks you obtained and the total for each. Use 1100 or 1200 for the boards to match your result card.
- Check the weights. They are set to the Session 2025-26 official 50, 40 and 10. Change them only if your admission year notification differs; they must add up to 100.
- Read the result. The tool shows your aggregate, how much each part adds, and whether your NUMS test clears the pass mark.
| Result | What it means |
|---|---|
| Aggregate | Your weighted merit percentage out of 100. |
| NUMS test part | Your NUMS test percentage multiplied by its weight, the biggest single piece. |
| FSc part | Your FSc percentage multiplied by its weight. |
| Matric part | Your Matric percentage multiplied by its weight. |
| Eligibility / note | Whether your NUMS test meets the pass mark, or the NUMS test score a target needs. |
What Is the NUMS Aggregate?
The NUMS aggregate is a single merit percentage that mixes three results: your NUMS entrance test, your FSc or HSSC Pre-Medical, and your Matric or SSC. NUMS constituent, affiliated and armed-forces medical and dental colleges rank MBBS and BDS applicants on this one number, not on the test alone.
Each result carries a fixed weight. For Session 2025-26 the NUMS test counts for half, FSc counts for 40 percent and Matric for the last 10 percent. A high NUMS test score matters most, but strong FSc and Matric marks still move your merit.
The aggregate is not an admission guarantee. A college sets its closing merit each cycle from how many seats it has and who applies, so the same aggregate can win a seat one year and miss the next.
How Does the NUMS Aggregate Calculator Work?
Aggregate% = (Test/TestTotal x 100) x 0.50 + (FSc/FScTotal x 100) x 0.40 + (Matric/MatricTotal x 100) x 0.10NUMS test marks needed = ((Target - FScPart - MatricPart) / (TestWeight / 100)) x TestTotal / 100- Turn each result into a percentage: marks obtained divided by the total, times 100.
- Multiply the NUMS test percentage by 0.50, the FSc percentage by 0.40 and the Matric percentage by 0.10 (or by your own weights).
- Add the three parts. The sum is your aggregate percentage.
- In reverse mode the tool fixes the FSc and Matric parts, then solves for the NUMS test percentage, and marks, that reach your target.
Because the weights add up to 100, an aggregate always lands between 0 and 100 percent. See how to calculate a weighted grade for the general method behind this, or turn raw marks into a percentage with the marks percentage calculator.
NUMS Aggregate Example
A student has a NUMS test score of 150 out of 200, FSc 935 out of 1100 and Matric 990 out of 1100, with the Session 2025-26 weights of 50, 40 and 10.
- NUMS test: 150 / 200 x 100 = 75.0000%. Part: 75.0000 x 0.50 = 37.5000.
- FSc: 935 / 1100 x 100 = 85.0000%. Part: 85.0000 x 0.40 = 34.0000.
- Matric: 990 / 1100 x 100 = 90.0000%. Part: 90.0000 x 0.10 = 9.0000.
- Aggregate: 37.5000 + 34.0000 + 9.0000 = 80.5000%.
Reverse check: to reach an 80.5% aggregate with the same FSc and Matric, the NUMS test part must be 80.5 - 34 - 9 = 37.5, so the NUMS test percentage is 37.5 / 0.50 = 75%, which is 150 marks out of 200. All figures were computed in code and asserted when this page was built.
What Changes Your Aggregate the Most
Because of the weights, the same number of extra marks moves your aggregate by very different amounts.
The NUMS Test Carries Half
At 50 percent weight, the NUMS test is the strongest lever. On a 200-mark paper, each extra 10 marks is 5 percent of the test, which adds 2.5 points to your aggregate.
FSc Is the Second Half of the Battle
FSc carries 40 percent. On a 1100 total, 55 extra marks is 5 percent of FSc and adds 2 points to the aggregate, so FSc is nearly as powerful as the test per percentage point.
Matric Adds the Least
Matric carries only 10 percent, so even a big jump in Matric marks moves the aggregate a little. It still breaks ties when two applicants are close.
The Board Total You Use
Dividing by 1200 when your result was out of 1100, or the reverse, shifts every percentage. Match the total to your own result card.
MBBS vs BDS and the Pass Marks
The aggregate formula is the same for MBBS and BDS, but the NUMS test pass mark differs. These minimums are from the NUMS Session 2025-26 advertisement.
| Item | MBBS | BDS |
|---|---|---|
| Aggregate weightage (2025-26) | Test 50, FSc 40, Matric 10 | Test 50, FSc 40, Matric 10 |
| NUMS test pass mark (2025-26) | 55% | 50% |
| HSSC minimum (2025-26) | 60% | 60% |
A pass mark lets you apply; it does not set the merit. The foreign-seat alternative is MCAT-USA or UCAT-UK at 50 percent, per PMDC Admission Regulations 3(C). The closing aggregate is almost always far above the pass mark at competitive colleges.
When to Use This Calculator
After Your NUMS Test Result
Combine your three results into one merit number as soon as your NUMS test score is out.
Before the Test, to Set a Target
Use reverse mode with your FSc and Matric already known to see the NUMS test score an aggregate goal needs.
Comparing MBBS and BDS Plans
Your aggregate is the same for both, so compare it against each program pass mark to see where you qualify to apply.
Checking a Blog or App Figure
Re-run the numbers here, where every step is shown, instead of trusting a single figure with no working. See how to calculate marks percentage for the basics.
Common Mistakes
1. Confusing the NUMS Test with the National MDCAT
NUMS runs its own NUMS MDCAT. It is separate from the UHS or PMDC national MDCAT. Enter your NUMS test score here.
2. Using the Test Score as the Aggregate
The NUMS test is only half the aggregate. A strong test with weak FSc still lowers your merit.
3. Mismatching the Board Total
Entering 1100-based marks against a 1200 total, or the reverse, changes every percentage. Use your own result totals.
4. Treating the Aggregate as a Merit Prediction
This tool never predicts admission. Closing merit depends on seats and applicants each cycle and is not fixed.
5. Using an Old Weightage
Weightage can change across years. Confirm the 50, 40 and 10 split in the NUMS notification for your admission year, and edit the weight fields if it differs.
Accuracy and Limitations
The arithmetic is exact for the marks and weights you enter. What it cannot know is how each cycle will differ.
What it calculates accurately
- The aggregate from any weights you enter that sum to 100, to four decimals.
- The NUMS test marks needed for a target aggregate.
- Any board total you enter, including 1100 and 1200.
- The 2025-26 NUMS test pass marks for MBBS and BDS.
What it does not account for
- Closing merit or your chance of a seat at any college.
- Weightage changes in later admission cycles.
- College or quota rules that differ from the central NUMS formula.
- IBCC equivalence marks for A-levels and O-levels, and deductions.
How We Calculate Your Aggregate
Frequently Asked Questions About the NUMS Aggregate
How is the NUMS aggregate calculated?
Add the NUMS test percentage times 0.50, the FSc percentage times 0.40 and the Matric percentage times 0.10. Each result is first turned into a percentage of its own total. These are the Session 2025-26 official weights.
What is the NUMS weightage for MBBS and BDS admission?
For Session 2025-26 the weightage is NUMS test 50 percent, FSc or HSSC 40 percent and Matric 10 percent. It is the same split for MBBS and BDS. Re-check the notification for your admission year, as it can change.
Is the NUMS MDCAT the same as the national MDCAT?
No. NUMS conducts its own entrance test, the NUMS MDCAT, which is separate from the UHS or PMDC national MDCAT. Enter your NUMS test score in this tool.
What NUMS test total should I enter, 200 or something else?
Use the total printed on your own NUMS result card. The field defaults to 200, which is the usual NUMS MDCAT total; edit it if your year or test differs.
How many NUMS test marks do I need for a target aggregate?
It depends on your FSc and Matric. Switch to reverse mode, enter those marks and a target, and the tool shows the exact NUMS test marks required.
What are the NUMS pass marks and minimum FSc?
For 2025-26 the NUMS test pass mark is 55 percent for MBBS and 50 percent for BDS, and the minimum FSc or HSSC aggregate is 60 percent. These let you apply; they do not set the merit.
My board result is out of 1200, not 1100. What do I enter?
Enter your actual marks and set the total to 1200. The tool divides by whatever total you give, so your percentage stays correct.
Can this tool predict if I will get admission to NUMS?
No. It only computes your aggregate. Closing merit changes each cycle with the number of seats and applicants, so no honest tool can promise a seat.
Can I change the 50, 40 and 10 weights?
Yes. The three weight fields are editable and default to the Session 2025-26 official split. They must add up to 100. Change them if your admission year notification uses a different split.
Where does this formula come from?
From the NUMS Centralized Admissions MBBS and BDS Session 2025-26 Combined Advertisement on numspak.edu.pk, read on 4 October 2026 and cited in Sources.
Is my data saved anywhere?
No. The calculation runs in your browser and nothing is sent or stored. Save keeps a copy only in your own browser.
Sources
- NUMS Centralized Admissions MBBS/BDS Session 2025-26 (Combined Advertisement, weightage 50/40/10) (National University of Medical Sciences admissions portal, read 2026-10-04; session year 2025-26).
- NUMS admissions portal (notifications and merit schedule) (National University of Medical Sciences, read 2026-10-04).
- National University of Medical Sciences official site (NUMS, read 2026-10-04; check here for your admission year criteria).
Related Guides
Related Calculators
Need another marks, percentage or GPA tool?
Explore all education calculatorsThis is an educational estimate, not an official merit list, admission guarantee, or affiliated with NUMS or any university. It uses the NUMS Session 2025-26 official weightage (NUMS test 50 percent, FSc or HSSC 40 percent, Matric 10 percent). Weightings change each cycle, and the 2026-27 criteria were not published officially as of 4 October 2026, so confirm the current official NUMS notification on nums.edu.pk or numspak.edu.pk for your admission year before you rely on any number. Spotted an error? Let us know.
Author
Shakeel Muzaffar is the Founder and Editor-in-Chief of MultiCalculators.com, bringing over 15 years of experience in digital publishing, product strategy, and online tool development. He leads the platform's editorial vision, ensuring every calculator meets strict standards for accuracy, usability, and real-world value. Shakeel personally oversees content quality, formula verification workflows, and the platform's commitment to publishing tools that are genuinely useful for students, professionals, and everyday users worldwide.




