Body Fat Calculator

Quick answer

A body fat calculator estimates the share of your weight that is fat using the US Navy tape method. Enter your height, neck and waist (and hip for women). A man who is 180 cm with a 38 cm neck and 90 cm waist has a body fat of about 20 percent, in the average range.

Updated 2026-09-09By Shakeel MuzaffarReviewed by Dr. Abdullah Khalil, MBBS
Try
Health
Sex
Units
Your height. Use cm in metric or inches in imperial.
Measured just below the larynx. Use cm or inches.
At the navel for men, at the narrowest point for women. Use cm or inches.
Women only, at the widest point. Leave blank for men.
Optional. Add your weight to also see fat mass and lean mass.
Body fat
--
Category--
Fat mass / Lean mass--

Calculations run in your browser. Inputs are not sent to our servers; anything you Save stays in this browser only.

Saved results (0)

How to Use the Body Fat Calculator

  1. Choose your sex and your units (metric or imperial).
  2. Enter your height, neck and waist measurements (and hip for women).
  3. Optionally add your weight to see fat mass and lean mass.
  4. Read your body fat percentage and category.

Here is what each result means:

ResultWhat it means
Body fatThe estimated share of your weight that is fat.
CategoryThe fitness band your result falls in for your sex.
Fat / Lean massYour fat and fat-free weight, if you enter weight.

What Is Body Fat Percentage?

Body fat percentage is the proportion of your total body weight that is fat, as opposed to muscle, bone, organs and water. Two people can weigh the same yet look very different because one carries more fat and the other more muscle. Body fat percentage captures that difference in a way that weight alone, or even BMI, cannot.

This calculator uses the US Navy tape method, which estimates body fat from simple measurements of your height, neck and waist, plus your hip for women. It relies on the fact that fat tends to gather in predictable places, so the size of those areas relative to your height predicts body fat reasonably well without special equipment.

The result is an estimate, typically within a few percent of a clinical measurement such as a DEXA scan. It is most useful for tracking change over time: measuring the same way every few weeks shows whether you are losing fat or gaining muscle, which the bathroom scale can hide. It is a screening guide, not a medical diagnosis.

How Does the Body Fat Calculator Work?

It applies the US Navy formulas, which use the base-10 logarithm of your measurements.

Men: men use waist minus neck and height
Women: women add the hip measurement
  1. Measurements are converted to centimeters if you use imperial units.
  2. The waist, neck and height (and hip for women) go into the formula for your sex.
  3. The result is your estimated body fat percentage.

For related measures, see the BMI calculator and the waist to hip ratio calculator.

Body Fat Example

A man is 180 cm tall with a 38 cm neck and a 90 cm waist.

Calculation: the waist minus neck is 52 cm. Putting the logs of 52 and 180 into the men's formula gives a body fat of about 20 percent, which sits in the average range. Adding weight would also show the fat mass and lean mass in kilograms.

Body Fat Categories by Sex

Healthy ranges differ for men and women because women carry more essential fat.

CategoryMenWomen
Essential fat2 to 5%10 to 13%
Athletes6 to 13%14 to 20%
Fitness14 to 17%21 to 24%
Average18 to 24%25 to 31%
Above average25% and up32% and up

These American Council on Exercise ranges are a useful guide, not strict rules. Some essential fat is vital for health, so a very low body fat is not a goal for most people. The fitness and average bands cover the large majority of healthy adults.

Comparing Body Fat and BMI

Both screen for healthy weight, but they measure different things.

MeasureUsesStrength
Body fat %Tape measurementsSeparates fat from muscle
BMIHeight and weightQuick, needs no tape

BMI is faster but can mislead for very muscular people, who may show a high BMI with low body fat. Body fat percentage avoids that by measuring fat more directly, so the two together give a fuller picture than either alone.

What Affects the Result

Measurement Accuracy

Use a snug, level tape and measure the same spots each time. Small errors change the estimate.

Sex

The formula and healthy ranges differ for men and women, so choose the correct sex.

Body Shape

The method assumes a typical fat distribution, so it is less accurate for unusual body shapes.

When to Use a Body Fat Calculator

Tracking Progress

Measure every few weeks to see fat loss or muscle gain the scale can hide.

Setting Goals

Aim for a healthy category rather than just a target weight.

Fitness Planning

Understand your starting point before a training or nutrition program.

Common Mistakes

1. Measuring in the Wrong Place

Measure the neck below the larynx and the waist at the navel for men, the narrowest point for women.

2. Mixing Units

Keep all measurements in the same units and set the units toggle to match.

3. Choosing the Wrong Sex

Men and women use different formulas and ranges. The wrong choice skews the result.

4. Pulling the Tape Too Tight

A tape that is too tight or too loose changes the numbers. Keep it snug and level.

5. Treating It as Exact

It is an estimate. Use it to track trends, not as a precise clinical figure.

Accuracy and Limitations

The US Navy method is a validated estimate, usually within a few percent of a clinical measurement.

What it calculates accurately

  • A body fat estimate from simple measurements
  • Fat mass and lean mass if you add weight
  • Trends over time when measured consistently

What it does not do

  • Match a DEXA or clinical scan exactly
  • Work well for very unusual body shapes
  • Diagnose any medical condition
  • Replace advice from a health professional

How We Estimate Body Fat

Method
The US Navy tape formulas, using the base-10 log of waist, neck and height (plus hip for women).
Inputs used
Sex, units, height, neck, waist, hip (women) and optional weight.
Assumptions
A typical fat distribution; accurate, consistent measurements; imperial values converted to cm.
Rounding
Body fat and mass to one decimal.
Edge cases
The waist must exceed the neck (waist plus hip for women), or no valid result is given.
Last reviewed
2026-09-09.

Frequently Asked Questions

What is a good body fat percentage?

It depends on sex. For men, the fitness range is about 14 to 17 percent and average is 18 to 24 percent. For women, fitness is about 21 to 24 percent and average 25 to 31 percent.

How do you calculate body fat with a tape measure?

The US Navy method uses the log of your waist minus neck and your height for men, adding the hip for women. This calculator applies those formulas for you.

How accurate is the US Navy body fat method?

It is usually within about 3 to 4 percent of a clinical DEXA scan for most people. It is best for tracking change over time rather than as an exact figure.

Where do I measure my neck and waist?

Measure the neck just below the larynx, sloping slightly down at the front. Measure the waist at the navel for men and at the narrowest point for women.

Why do women need a hip measurement?

Women store more fat around the hips, so the women's formula includes the hip to estimate body fat accurately. The men's formula does not use it.

What is essential body fat?

Essential fat is the minimum needed for health, about 2 to 5 percent for men and 10 to 13 percent for women. Going below it can be harmful.

Is body fat percentage better than BMI?

It is more informative because it separates fat from muscle. BMI is quicker but can misclassify very muscular people as overweight.

Can I use this in pounds and inches?

Yes. Set the units toggle to imperial and enter inches and pounds. The calculator converts your measurements internally.

Is my information saved?

No. The calculation runs in your browser and nothing you enter is stored or sent anywhere, unless you choose Save, which keeps the result only on this device.

Sources

Related Guides

Related Calculators

Looking for more health tools?

Explore all health calculators

This calculator estimates body fat percentage using the US Navy tape method, which uses body measurements rather than weighing fat directly. Enter your height and neck and waist measurements (plus hip for women). It is an estimate, typically within a few percent of a clinical measurement, and is not a medical diagnosis. Speak to a professional for health decisions. Spotted an error? Let us know.

Author

shakeel-Muzaffar
Founder & Editor-in-Chief at  ~ Web ~  More Posts

Shakeel Muzaffar is the Founder and Editor-in-Chief of MultiCalculators.com, bringing over 15 years of experience in digital publishing, product strategy, and online tool development. He leads the platform's editorial vision, ensuring every calculator meets strict standards for accuracy, usability, and real-world value. Shakeel personally oversees content quality, formula verification workflows, and the platform's commitment to publishing tools that are genuinely useful for students, professionals, and everyday users worldwide.